Expert Tips Archive	[ Back ]

Bathroom Product Information

MTI makes a whirlpool bath even more appealing.

A whirlpool bath is rated one of the most desired fixtures for the bathroom. However, the chore of cleaning soap residue and body oils that can build up in the plumbing system, leading to bacteria growth, may discourage some from installing one in their own home.

MTI has a solution for those worries with its patented self-cleaning Fill-Flush System. This whirlpool system offers a safe, clean bath every time. The Fill-Flush System was designed to allow water to fill into the tub through the jets, resulting in a fresh supply of water that is circulated through the plumbing and air lines each time the tub is filled. It also allows the user to use bubble bath, aromatherapy oils and bath salts.

After enjoying your whirlpool bath, cleaning your MTI whirlpool is a simple four-step process:

1. After draining the water, close off the jets by pushing them in.
2. Open the cleaning filter cap and pour in cleaning solution.
3. Turn on the water. The water mixes with the cleaning solution and special check valves allow the cleaning solution to circulate through the internal plumbing system, quickly flushing any residue out of the tub’s suction and down the drain. Continue for five to 10 minutes.
4. Wait three minutes. Pull open jets and run water for approximately 30 seconds.

That’s all there is to it.

The Fill-Flush System saves you water and time because it requires only five gallons of water and five to 10 minutes to thoroughly clean the entire plumbing system, including the water line, air line, valves, jets, and pump after each use.

For a demonstration of the Fill-Flush System in action, visit www.mtiwhirlpools.com.

[ TOP ]